15BYHJ-POM geared pm stepper motor/ step angle 18° with POM gearbox
15mm series of PM stepper motors use permanent magnet rotors and
are commanded by electrical pulses. The motors are constructed with
the housing at the diameter of 15mm.
Before the involvement of any of gearboxes, the step angle was
initially to be 18° and the motor itself rotated by having the
holding torque as much as 40g.cm maximally.
From the above picture, you see that our PM stepper motor has been
assembled with a planetary gearbox made from POM while the gear
ratio is determined at 1:50.
Due to the space constraint inside the motor, a PCB (printed
circuit board for short) is put outside and welded with the out
leads. Around the PCB, a black cover made from PBT is especially
used to prevent any dusts to ensure the PM stepper motor can
operate properly in a good working condition for a longer term.
They are widely applied to Fax paper cutter, scanner, copy machine,
IP camera as well as healthcare products.
|No. of Phase|
No-load Staring Frequency